Hi stue though you had gone missing in action as not seen you on YouTube glad you are well.
When I fitted my D post I took measurements from the C post to the D post and took measurements from the inner wheel arch to the D post.
I used self tapping screws to hold it in place then refitted the...
I have just got my hands on a range rover p38 4.6 engine and would like to rebuild it and fit it into my 3500s.
I have a 5 speed LT77 gearbox fitted at the moment so should cope with the extra power and torque.
I would like to keep it on HIF carbs. I no not ideal and will restrict power output...
I don't now how but I have lost the pictures for the repairs of the rear inner sill computers not my thing.
So as you can see I have cut off the D post and inner part of the D post and also repaired part of the wheel arch.
Hope I have got the new D post in the right place bit late now. I did...
My friend who is a snap on rep when I asked the question about the warranty said hand tools are warranted for life against breakage only and not if they are worn out.
Electrical tools for 12 months ie mig welders and they only have to supply spare parts for 8 years.
Hi stue can you please slow down you are making me look very slow.
Like me you are finding a lot more rust than expected due to previous poor repairs.
I found four patches on top of each other on the near side rear sill.
Keep up all the good work and hope to see you and your car one day.
Hi stue I am also restoring a p6b see project t rex. I love watching you on YouTube I am behind you as finding time is my problem.
I am fitting replacement D post at the moment as it was rusty top and bottom. I will post sum more picture soon.
Keep up the grate work as it gives me the drive to...
Don't no how but I have lost the picture of the rest of the repair to the rear of the sill.
So now started on the outer sill at the front. Found poor repair to the jacking point and bottom of the A post has rust holes.
Good job that when I bought this car it came with a 1971 2000 TC so I drilled...
My snap on mig welder that I bought in 1985 stop working in the last week. So I have bought a R tech 180 mig welder. R tech were a delight to deal with and it is like day and night compared to my old transformer welder and does not blow holes all the time.So now back on with project T Rex if I...
Just moving down the inner sill cutting out more rust and previous repairs. Once I have finished the inner sill i will then start on the outer sill. Just a bit worried about cutting inner and outer sill off at the same time.
Hi Tom W I still have a lot more to do so hopefully get the hang of welding again. My mig welder was purchased in about 1985 when I used to do hot rod racing and built my own cars. The mig has only 4 settings and the next seting is too high and blows holes in the metal. I am thinking of buying a...
So car now in the garage so let's get started. Out with the angle grinder and got cutting out the rust one piece at a time. First rusty piece now out. Made up new piece and welded in. Welding not pretty but hopefully strong.