Thanks for that Harvey, I'll stop worrying about it then! Rear servo bolts.....might need some handholding there?
My sump plug is goosed, so if you have one I can buy I would be very grateful
Hi all, after removing the gearbox sump to replace the leaky gasket I discovered a loose pipe in the pan - hopefully pics attached. I don't think it came off when removing the sump.
It's obvious where the pipe lives and having offered it up it is staying in place but I'm obviously concerned it...
Hi all, I've recently bought a '72 V8 that's been off the road for over 10 years and have a couple of electrical niggles:
- The o/s sidelight is not working despite the bulb and earth being fine. I've checked the fusebox and both red and black wires are getting 12v. On dismantling the light...
I have a full set of mismatched wings in very average condition - will need a respray etc. Keen to get rid of them so they can be had at a nominal price. I'm in Aberdeenshire. 07818038455. Thanks
Thanks Demetris. I have looked at replacing this before. when my middle box first started to blow I was going to try and put together a single silencer affair that replaced the whole rear section. I do worry about doing a proper job as the work would be partially visible!
Hi Dave, thanks for that. Yes I do mean the box near the diff. I'll see if I can find one then. Out of interest why is it preferable to remove the front box over the middle? I'm not sure I could bring myself to remove a healthy box but perhaps I could be convinced for the rasp you mention!
The middle can of my 3 can exhaust is in pretty poor condition. Is it a good or a bad idea to replace this with a straight-through pipe? I've heard the standard setup is quite restrictive but I won't want to the car to sound antisocial or else just crap.
Am I right say that because a. Rover...
Just to let you all know that all noises have stopped completely! Testrider you appear to have been correct! or let's hope so. Thank you all for the input :)
Hi thank you for all the replies.
I sincerely hope it is something as straightforward as a stone Testrider! As the o/s doesn't seem to be binding I had ruled out the brakes as a culprit. Certainly there are no scores on the disc.
i'll try and locate the noise with a screwdriver and get the car...
There is notchiness on one side. I took the wheels off and had the engine turning them. Hell of a noise for a UJ or a bearing. I've made a video and the noise is clear
http://m.youtube.com/watch?v=s2PWraFRCKs
arms elbows and hubs seem OK. With the n/s wheel jacked up I can hear the noise if I rotate the wheel. It sounds like it's coming from the diff but there are no such noises if just the o/s wheel is rotated. I guess this eliminates the diff as the culprit thankfully. The UJs are free of play and...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.