Search results

  1. rover100rich

    P4 80

    Use 20/50 motor oil not ep80/90
  2. rover100rich

    Half door skin

    Hi all, im doing a front half door skin and got a wadhams panel, just need to ask do you leave the piece of angle which comes spot welded to the panel in place when you weld it in or remove it? Thanks, rich
  3. rover100rich

    MINSTREL NEW CLOTHES

    I fitted a small water filter at the gun which sorted that problem for me
  4. rover100rich

    Door to door seals

    The picture shows the door to door and wing to door seal from wadhams against the original, the new one is wider so the front door catches the seal on the front of the rear door as it closes, is there a better seal available or a work around this please, rich
  5. rover100rich

    Ignition system

    38 degrees +/- 4 degrees
  6. rover100rich

    Back after not being on here for years

    Nice to see you back gar, your car is looking good, only just returned myself, starting to restore my p6 now, cheers rich
  7. rover100rich

    Power spark distributor with electroninic ignition

    I think tony has purchased the complete power spark distributor, ive fitted one to my mgb but havent road tested it yet, easy to fit, just need to use a strobe to set timing, recommended by practical classics i think
  8. rover100rich

    p6 rpi video ,anyone here?

  9. rover100rich

    Replacing vinyl

    Auto Seat Vinyl - Martrim Car Trimming Supplies try martrim
  10. rover100rich

    Searching for our rover 100

    Rover P4 Drivers Guild Rover P4 Drivers' Guild ask the p4 guild chaps,the facebook page is much more active than the forum nowadays,you dont need to be a member of the guild to post,please give reg and colour,good luck
  11. rover100rich

    S2 V8 Wiring diagram

    ie this better
  12. rover100rich

    S2 V8 Wiring diagram

    is this any help
  13. rover100rich

    S2 V8 Wiring diagram

    looking at my manual,there are a number of wiring diagrams for the "new look "models,rhd we need to know the chassis suffix,A through to E and is it an auto or an S?
  14. rover100rich

    S2 V8 Wiring diagram

    Rover P6 wiring diagrams | Facebook are these pages by mark on facebook any help?im not on f/b myself anymore
  15. rover100rich

    hi bernie,do you have more pics of EUO671c please ,thanks rich

    hi bernie,do you have more pics of EUO671c please ,thanks rich
  16. rover100rich

    Recommendations for electronic ignition Distributor?

    mate has a stag with rover 3.5 ,it has a 123 dizzy and goes like gangbusters,mine has lumenition which i like as there is a large heatsinkfor the electronics as opposed to ones that fit under the dizzy cap,electronics are killed by heat
  17. rover100rich

    Sleipnir/PAE (OR Rovey to Phoebe!) - SOLD

    must be a wrench for you ,hope your going to be ok and stick around,good luck,rich
  18. rover100rich

    MGBD

    get well soon mark,hope you had one of our stents put in ,i had to have 10 inserted 2 years ago and was back in work after week and a half,good luck
  19. rover100rich

    Rover P6B Series One ignition switch - what else is compatible?

    Electrical wins lists ignition switch and key for series 1 send an email to them
  20. rover100rich

    Rover P6B Series One ignition switch - what else is compatible?

    J R Wadhams Ltd | Ignition switch: 7/8 wire this not it?
  21. rover100rich

    Bad lower right ball joint removal?

    http://www.roverp6parts.com/extractingbottomballjoint.html
  22. rover100rich

    lucky

    1970 Stunning series 1 V8 3500 For Sale | Car And Classic
  23. rover100rich

    20k mile p5

    Duncan Ellison Vintage Car Specialist & Dealer i know its stupid money and not a p6 but check out the pics of this p5 ,the engine bay in particular looks like new
  24. rover100rich

    p6 works rally car for sale

    1966 Rover 2000 P6 ‘Ex-Works’ car. For Sale | Car And Classic
Top