My gearbox leaks a little bit.
I want to put some oil in it.
In the opening inside the car (gearboxtunnel) i can put oil in it but how much?
Is the amount right if i can feel it with my finger?
I 'll check these points and hopefully will find the solutions. The engine mounts are new and the two half sections of the prop shaft are correct together with the marks allignement.
One universal joint of the drive shaft is not good so i will replace this one. Thanks for the comments!!
I am looking for an reliabel adres for restore my differential. I have the "clunk" if i change gear.
I think to much play between pinion and crownwheel. I also have vibration from the propshaft i think.
Adresses also in Germany is possible.
Hello. I am looking for a radiator cap f (1,5) for a rover 3500S who is double acting because i put an expansion tank on the car. This expansion tank is a overflow tank (from a susuki alto) and is from plastic with a plastic cap.
Has somebody an idea? Is it wise to put away the coil of the...
I had this with the back gear. I changed the bearings from the layshaft and one from the mainshaft, and it was gone.
Exept one bearing all the others you can get in a normal bearing shop (ich spreche Deutsch)
If the temperature is below zero my throttle refuse to come back .
Only if i correct it with my feet the revs go down.
If the car runs for 5 minutes the heat increase in the engine and it comes back again. I have tried to lubricate the linkcages without result. I suspect some where...
Could enybody give me some advice , the heated lines of the rear windows do not work.
I have voltage where the lines meet the vertical thicker lines of the rear window(left and right)
But the horizontal lines have all no voltage or resistance. I can not seen that there is damage in the...
To day i succeed to fit the engine mountains. I had to work with another person lifting and lowering the engine. It was for me not an easy job i have to comit. First i removed the old rubber-mountings together with the brackets and then put the new rubbers on the brackets and then the best...