Search results

Hi all. I have just dismantled kitty's passenger side suspension/steering and I really need to get the top and bottom ball joints out. Book says I need a tool for it. Anyone know where I can get one?

The lower seal showed up in post, very pleased. Does anyone make the rubber elbow that connects internally with the drain tubes? Mine are a bit ropy.

Cheers I have just ordered a seal, never heard of Famous four before.

Hi, I'm working om Kitty my series one P6 which has suffered a very rotten heater box. I have been lucky on ebay to find a very good later box which just needs a freshen up with paint. The original had that awful foam which had turned to dust, however the new one has a very good rubber one. What...

So is that bust pins on the front only? If not can I still use them?

Needed rear doors for series one P6 2000. The cleaner the better but good inner shells.

Hi, yes it looks like I will have to either alter the mounting ring or remover the tabs from the units. As they look like they would sit a little prouder than that of sealed beams it could be an option.

Hi all, I have a headache. I have this odd desire to be able to see where I am actually going at night, when Kitty is at last on the road, so have bought some new headlamps. I read up on the advice that to by the LUCAS branded units as many of the generic ones have proved poor quality. So I...

Hi The Rovering Member Sorry to be a pain but the shield I had picked up turns out to be for a single carb and according to the parts book my TC needs a specific one for the Twin carbs. Sods law really. She has been robbed of a number of small annoying bits and others have been meddled with...

Hi thanks for the offer but I just picked one up before I got your message. Thanks for the offer.

Hi my heater box is corroded at front, any one got a nice one going? Also my carb heat shield is missing, any one got one?

Thanks for the advice

I have a series 1 with some poor doors. I have only seen series 2 around for sale. What are the differences between them?

I'm looking for some doors for my series 1 P6. Front passenger is the worst on my car. I'm in Teeside but will pay for courier for good doors.

Do you have any good series one doors?

Found a nice NOS pair so will keep originals as spares

My F reg P6 has these fitted, apparently from new as they have the correct wiring extensions etc. Anyone know if they are available? they are in good condition except one lens is missing, dang!

Pics of booy alignment.

Inner wing progress, pre paint]

I doesn't appear correct on the right side as sits out compared to left and left wing leans in too.

Hi sorry late but busy with my mum to Drs etc. News not as bad as feared thank gods. 90 and still causing havoc! I've sent you the £20 for the wing. Please could you send me the dimensions and an idea of weight for the parcel to go people. Also a prefered date for collection too please. colin

I have found that my boot panel on my project appears much lower than the level of the rear deck panel. Sould this be level across? If so how do I increase the hight? Advice would be welcome Ta.

Hi sorry late reply, my mother has taken poorly so everything got dropped. If you could pad it with cardboard that would be good. How would I get money to you?

I will have the wing if willing to pack for a courier?

Hi, I'm putting my F reg 2000TC back on the road and I really need help with so bits. I need a rear offside wing. She has a waist trim. My boot has a big dent so a better one would be good Rear doors Decent bumpers I'm in Teesside so North Yorkshire etc I could pick up. Any help would be great.