Search results

I remember that another mechanic once removed or replaced the diff. Possibly distance discs were left afterwards

Great drawing, thank you! As far as I know, there are small arrows or markings on the two drive shaft components. in our p6b with lt 77 a shaft from an automatic has been installed. That's a good thing. The markings also point to each other :) . I modified the mount. i can now adjust the...

we have a p6 3500 s that got an lt77. the car has vibrations, from 130 km/h. of course we have already fixed the usual factors: wheels, drive shafts, cardan shaft. my question is: can the installation angle (the bracket from the lt77 is self-made) be the cause?

good tip with the wheels! thx the car has vredestein sport trac 195 /70 14 , I make very little pressure (1.8 ) on the tires and drive. I don't have a good experience with rubber from wadhams, but he has probably no fault. the rubber bag for the gearstick was torn after a few weeks, the rubber...

a year ago we installed on front axle & rear axle the superflex.co.uk blue. the customer says it rumbles and i can confirm that. which rubbers are nice soft? the orgiginals from wadhams?

yes, the transmission tunnel is different. we know that but I do not care. i converted my mk1 to r380. I get along well with both versions btw: i still have a bw35 and a bw65 for sale ;-) thx

no, way too far away and too many bucks for transport

no I can not use, but thanks for the bad offer ;-)

oha...bad news

I am looking for a baseunit for restoration. can still roll, but does not have to.... I can't find anything on the continent

I'm looking for 4 good wings in burnt gray with original paint. the paint may be matt , but they should be so that the paint is worth preserving best regards jorgen

a wrong coil was installed ! wish a happy easter regards jorgen

the quality sucks today but i had the same problem with a sd1 distributor, so i look at the data of the coil again

It can't be a capacitor .. because I've just installed a new one from jrw

i still have a ballast resistor from mallory on the shelf. should we do this in between

I also noticed days ago... that the coil is very hot. after that I inststalled another suitable one, but the car still ran badly

i have a strange problem with the ignition (i think). first: everything is new! engine, ignition (fingers, contacts, capacitor, cap, spark plug cable,), carbs. but not the wiring harness or something like that. the car runs perfectly for about 10 minutes. then ignition failures begin and the...

both cannot be, because they are not the same

I would like to retrofit oil pressure and oil temperature. I should know what kind of screw thread this is. Please take a look at the attached picture.

where are the sheets mounted on the rocker arm ? front, back, on both sides? best regards jorgen

if any of you is near southern germany (freiburg) i look forward to a visit to paint black stripes on our road ;-) hehe how is the best measure between cown & pinion gear? we can not find it in the manual !

this is an engine with fun factor :) it is the 4.6 liter warrior. V8 Developments - 4.6 Litre Warrior Long Engine

so, once i disassembled an old diff on which the axes are sheared off. this is probably also due to too much flank play between the gears. question: do we set the right flank play with shims in the bearing?

I ask at ashcroft transmission, I've already bought several gears