Search results

I'm trying to get my 1968 2000 TC back on the road. The engine is poorly (loss of compression and worn bores) so has to be replaced. I have 2200 TC engine in good condition in store, plus a separately acquired pair of HIF6's complete with manifold. So far so good. The plan was to swap the...

I am in the process of awakening a ´68 2000 TC that´s been off the road since 1982. As the compression ratio was almost nil on a two cylinders, I removed the cylinder head to have a peep. Before doing that, the valve clearances were checked and found to be zero on number 3 and just over nothing...

Dear forum members! I am about to refurbish a -68 RHD 2000 TC (ex UK) that's been off the road since 1981. Of course, the brake system has to be completely renewed/rebuilt. The master cylinder is seized, thus probably past saving, and I intend to buy a new one but, this winter I scrapped a -66...

.. at Tradera, which in effect is Ebay in Sweden, these wheels are for sale. Does anyone know have information about them (makers, history etcetera)? Rover 3500 tillbehörsfälgar mycket ovanliga 4st

I have taken temporary care of a P6 2000 registred in may 1966, with a suffix C chassis number. The car's been off the road since 1983 and last time the engine ran was in 2005. Amazingly the engine hadn't stuck, and I'm now trying to make it run, but there are some snags. What I'm trying to...

I bought a pair of NOS front shock absorbers, part n:o 572994, and subsequently learned that they are intended for the 3500 with power steering. Does anyone know in what way they differ from the ones for cars with manual steering in terms of behaviour/performance and, why they were deemed...

Just removed and dismantled the brake master cylinder in my 2200TC fitted with the dual circuit brake system. During dismantling a lone dished washer suddenly appeared. Stupidly I had failed to notice what part it had been attached to. I didn't see it until after removing the tipping valve for...

Sorry for putting the query on this board, but people here seem to know where to turn for that elusive part. At a car meet today I met with the owner of this splendid P3 75 1949 who is in need of a couple of parts he's been unable to find in Sweden. The first item is the vacuum advance unit on...

During the past year and a half I’ve found help with every problem I’ve had on my -75 2200TC in this invaluable forum, but couldn't find any post covering this one. Help much appreciated. I am about to replace the diff mounting bushes on my ’75 2200 starting with the rear pair. As the original...

First I’d like to thank all those who have contributed to this forum, both those who have searched for help, and those who have taken the trouble to share their knowledge with others or, voice their opinions. Without you all I’m not sure I’d have dared to buy an old Rover, in my case a ’75 2200...