Hello
My gearbox leaks a little bit.
I want to put some oil in it.
In the opening inside the car (gearboxtunnel) i can put oil in it but how much?
Is the amount right if i can feel it with my finger?
Joop
Hello
I am looking for an reliabel adres for restore my differential. I have the "clunk" if i change gear.
I think to much play between pinion and crownwheel. I also have vibration from the propshaft i think.
Adresses also in Germany is possible.
Thanks
Hello. I am looking for a radiator cap f (1,5) for a rover 3500S who is double acting because i put an expansion tank on the car. This expansion tank is a overflow tank (from a susuki alto) and is from plastic with a plastic cap.
Has somebody an idea? Is it wise to put away the coil of the...
Hello
If the temperature is below zero my throttle refuse to come back .
Only if i correct it with my feet the revs go down.
If the car runs for 5 minutes the heat increase in the engine and it comes back again. I have tried to lubricate the linkcages without result. I suspect some where...
Hello
Could enybody give me some advice , the heated lines of the rear windows do not work.
I have voltage where the lines meet the vertical thicker lines of the rear window(left and right)
But the horizontal lines have all no voltage or resistance. I can not seen that there is damage in the...
Hello,
These measurements i made. The car is a rover 3500S with 10,5 :1 motor
2 cyl 10 bar 1 almost 11 bar
4 ,, 10,5 3 ,, 9 bar
6 ,, 9 5 10 bar
8 ,, 9 7 8,5 bar
Secund measurement with...
Hello
My watertemperture has never been at the gauge in the green area (Always in the wight). Except wenn the car is iddling. Then it raise to the green area. Then is also the Heather temp allright.Wenn I am driving it is too cold. I already changed the thermostat but this solved nothing. What...
Hello
As i was a child (50 years ago) i offen went to the neighbour who has as jaguargarage. I looked into the MK2 and remember the smell of the leatherinterior. I have not find this in the leatherinterieur nowadays. Do they not make this leather anymore? What is the name?
Hello
I have the following things done to my gearbox because it jumped out the
reverse gear:
Changed two conical bearings and one bearing from the mainshaft and
replace the reverse gear by a new one.
Also replaced sherical bush from the gearlever. I install a new clutch and
disc.
I filled up...
Hello
I am new here. I live in Holland and i own a rover 3500S since 1 year.
I followed for some months this forum and i am impressed of the specific technical knowledge of some members.
I hope i can get some help here.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.