Hi gastechnician if you private message me your address I will send the parts to you along with my bank details in side the parcel.
I will try and send out on Tuesday.
Thanks Paul.
Hi Gastechnician
I have sorted out the parts that I think you need. If they are the right parts and you still require them I can send them
To you for 25 rover bear tokens plus postage. Thanks Paul.
Hi gastechnician
I am 99 percent sure I have pipe from fuel pump to float chamber and float chamber top.
I will have a look at the weekend and let you know for definitely if ok with you.
Hi Ron
What have you done to your air filters ?
I was thinking of using montego filters and enlarging the snorkel on the air box.
I don't no if it would be better to use a air box and filters from a sd1 if they flow more air.
Thanks Paul.
I would like to say what a great forum this is I have been on many forum over the years but this one tops them all.
I would like to say a big thank you to all and especially the staff who make it possible have a great Christmas and hope the new year is a better one.
Paul
Hi stue just watched your last video as I will have to replace that part on my car. How did you bend the box metal to that shape.
Keep up the good work.
Paul
Starting to make up my Christmas list. So I am going to ask father Christmas (yes I do still believe in him that's probably why my kids get no presents).
For front and rear upper and lower screen rubbers. What experience have you had with the fit of wins, wadhams and Scots old auto rubbers...
Hi stue I have got to repair my boot shut to. Did you make the curved part on the right hand side or did you buy it as a repair panel.
Keep up all the great work.
Paul
I love your work and dedication stue. I am now a long way behind you now
I am finding it hard to find the time at the moment but I no I will get there in the end and will be worth it.
Hi stue though you had gone missing in action as not seen you on YouTube glad you are well.
When I fitted my D post I took measurements from the C post to the D post and took measurements from the inner wheel arch to the D post.
I used self tapping screws to hold it in place then refitted the...
I have just got my hands on a range rover p38 4.6 engine and would like to rebuild it and fit it into my 3500s.
I have a 5 speed LT77 gearbox fitted at the moment so should cope with the extra power and torque.
I would like to keep it on HIF carbs. I no not ideal and will restrict power output...
I don't now how but I have lost the pictures for the repairs of the rear inner sill computers not my thing.
So as you can see I have cut off the D post and inner part of the D post and also repaired part of the wheel arch.
Hope I have got the new D post in the right place bit late now. I did...
My friend who is a snap on rep when I asked the question about the warranty said hand tools are warranted for life against breakage only and not if they are worn out.
Electrical tools for 12 months ie mig welders and they only have to supply spare parts for 8 years.
Paul
Hi stue can you please slow down you are making me look very slow.
Like me you are finding a lot more rust than expected due to previous poor repairs.
I found four patches on top of each other on the near side rear sill.
Keep up all the good work and hope to see you and your car one day.
Paul
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.