Hello Everyone,
Cherryroverp6 here,
It has been quite a long time since I have posted onto these forums as I had to let my previous project go due to the bulk head rot. I ended up stripping my 68 2000 to the base unit an saving everything I could. I have Since acquired a 1966 2000 Tc that had...
Hello everyone,
This evening I was attempting to remove the drive shaft to check the u joints while the transmission was out. Apon attempting to fit tools at the rear yoke towards the diff I was unable to fit a socket or even a wrench behind it without hitting up against the tube. Is there any...
Hello everyone.
Recently I discovered that my rovers air ducts from the heater box are riddled with rust and scale. It extends from the windshield air vents to the passages underneath the plastic dash under the speedometer. All the way into the box section unbove the foot well/ pedals. The...
Hello everyone.
I have yet another mechanic gremlin. I suspect a clutch failure as she slips in third/fourth gear especially up little hills as in the revs surge very high with no speed increase at anything above 35mph. The clutch grabs at the very tip top of the throw :/ as well. Someone...
Hello everyone I've been continuing to try and find out why my 67 rover tc 2000 won't start. Ive set the timing to the EP mark on the flywheel to the camshaft. She no longer started after this. I've got compression and spark. Fuel, I proceeded to adjusting the distributor with no difference...
Hello everyone,
I have a slight problem on my 67 Tc 2000.I am trying to find the true lead setup for the distributor cap. I am wondering what the true #1 cyl lead is on the cap. Here is a photo. Any help would be greatly appreciated. As per properly setup distributor with it set 6 degrees.
Last major issue I seem to be having with my rover is removing the ball joint as it is very worn. I can't seem to find a mechanic who can give me a good idea of how much labor it will take nor to time. Let alone a proper tool. I've been searching left and right for the proper ones. Any advice...
Hello everyone.
I currently have my p6 with girling Calipers on wheel ramps looking at them. My hand brake engages the mechasim on the calipers, but doesn't stop the car. I don't seem to be getting movement nor wear on the discs. The pads have plenty of meat left. And the brake pedal has very...
Hello everyone,
I am new to these forums an Excited to be a part of them. Almost a year ago I acquired a 1967 Rover Tc 2000 that had been sitting since 2000 in a back yard in Vermont USA. Before its Previous owner had fallen ill it was his pride an Joy and Now is mine. It came very rough with...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.