I purchased this as a non runner with the intention of getting it started and restoring it. Massive project as I believe it was used for rallying of some kind. Dents all over the place, no seals so water is getting in every where. Roof has been butchered to install a roll cage. Dash is...
I have some Su Hif carbs fit to my 3.5Ltr v8. I have cleaned them up as the pistons were seized. They move freely now. I have now put oil into where it goes but since then the pressure has increased a fair bit to raise the pistons. Obviously this is supposed to happen but it there anyway of...
I have purchased a 1977 mgb gt 1.8. The engine and gear box etc have been upgraded and has been fit with a rover sd1 3.5ltr v8 engine and gear box.
My question is do i still need a ballast resistor? I basically brought this as a non runner and when i brought it the resistor was attached but not...
I have recently purchased a mgb gt 1977 that has been converted to a rover sd1 v8. I brought it as a non runner and hey presto it's still a non runner. It has been sat for many years so was slight seized but engine is moving. I've stripped the fuel pump and that now works, rebuilt the starter...
I have recently purchased a 1977 mgb gt that has been modified with a sd1 gearbox and 3.5ltr rover sd1 v8 engine. Currently a non runner and battered but I'm hoping to restore it
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.