Hi all ,i,m looking to rebuild my 3500 engine ,any suggestions where to get parts, pistons ,cam shells ,mains etc, i was thinking rimmer bros or real steel ,what are yours thoughts please John.
Hi Harvey, did.nt get to test drive today, as I had the sump off i checked the filter which was quite dirty also to my horror there was part of a rubber seal in there, so took of rear servo and part of the seal was missing AGAIN ,As you know this had recently been replaced what i thought was a...
Hi me again, i have altered the throttle linkage so now i have full travel on cable, do you know where roughly oil level should be in box, as i dont know if i have correct length , dip stick as mine is short ,it comes inside the car, as this is in a ford pop hotrod Please
Hello all ,i,m looking for some help regarding how much travel should there be from idle to full throttle from crimp on cable, i have set cable with the sump off to make sure it is at the correct start point ,it is BW 35 box and i am running a holley carb, could anyone please measure what they...
Sorry would,nt let me write anymore, i have taken some pics i will try to send them to you, do you know how much travel i should have on the cable, it only lifts up about 3/4 inch, John
Hello again Harvey hope you are well.i.m back out in the garage again, working on pop, i have set the kickdown crimp with the sump off to get it right, the cam is at rest as it should be with just a little slack at linkage as you explained ast time we spoke,I only have about 3/4 inch of travel...
Hello once again Harvey hope you have been well in these trying times, when you gave me advice about cam on kickdown valve should the cam travel all the way on acceleration please.
Hello again Harvey, trying to get the correct adjustment on kickdown cable, i have had the sump off again, and i can see where the cable attacthes to the cam ,just wondered if you have any pictures of how this should sit against the valve please, John
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.