Advice rust removal

I have been removing small Nick's in underseal till I see good metal. Then will treat and paint .this is in the boot wheel arches corners lots of sealer there should I get it all out .or do you think will be holes there .should I leave it alone till I get the bodywork done properly. Just trying to save it were I can
 
Personally I would take it right back to bare metal, treat with a rust converter then paint.

The main bit to concern yourself back there is just under those bits, where that bolt goes into the side of the boot in your final picture.
 
Everyone is going to have a different opinion on this, from stripping to a bare shell and blasting it, to pulling the carpet back over it and driving on.

I would probably get a sharp scraper and remove all the old seam sealer and paint and abrade with a small wire wheel. Hopefully there wont be any holes and you can treat with rust converter and paint with POR 15 or similar.
Best check the underside as well for flaking underseal.
 
Everyone is going to have a different opinion on this, from stripping to a bare shell and blasting it, to pulling the carpet back over it and driving on.

A lot of it also comes down to cost. It's cheap to sand it down, prepare and paint with hammerite.. more expensive and time consuming to blast it, and to go even further and strip it down completely :)
 
Yes thx Cris just gonna remove and paint for now as first p6 and just bought the car
Dont know what else will find yet
Cheers
 
As Quattro says, it’s worth using a rust converter to neutralise any corrosion. If you’ve caught it soon enough, you should be able to stop it getting any worse, and it will last for a good few years.

Definitely, it’s a good idea to check over the rest of the car throughly before getting too stuck into one area, if you’re not sure what else you find. Also, whether you can or can’t weld, and how much of a project you want will influence how throughly you want to prod at that area. If you’re paying someone to do the work, it’s usually best to replace larger areas, or complete panels to original seams. In which case, it doesn’t really matter whether you have one hole or lots in a given area. The cost is similar, until the repair spreads to the next panel.

If you want to go further, I’d start by removing anything flaking, or anything that comes off easily by scraping, and keep going until it’s not easy to flake off. Chip off any “metal” that’s started to corrode into laminates. Gentle tapping with a hammer, or scraping at it with a screwdriver will find anything that’s no-longer sound. Be prepared for this to uncover much more than you can first see though.

If the original coating is no longer properly adhering to the base metal, it actually makes things corrode faster than if they were just left bare. Unfortunately if you find holes, then the only way to properly sort it is to cut out the bad metal and replace with new. By the time the first hole appears, it’s usually paper thin over a much larger area, and trying to weld up just the hole never works.
 
Back
Top