Best fitting windscreen rubber ?

cobraboy

Well-Known Member
Having ordered a new screen at the NEC on the Pilkington stand I need to decide what to do regarding the rubber.
I have read that people have had trouble with the fit of new rubbers, so what to do ?
Are Scotts from Aus good and worth the money ?
Do Wins rubbers fit well ?
Do I clean up the old one and put it back ?
Advice appreciated, and fitting tips as well.
 
Cobraboy, I replaced the rear screen rubber with one I got from Winns a couple of years ago. It is a bugger of a job, you may need a sharp chisel and mawl (mallet) to remove some of the rock hard rubber from the channel! Not sure if that applies at the front but the rubber fitted fine. Any small concerns with the final fit gradually rectified themselves over time. I hope this helps.
 
Back
Top