Oil pressure.

cant remember the size, but its just a normal but fairly large spanner, if your stuck a pair of mole grips will do it they are not screwed in that tight
 
ok looking into it I think its a 18 mill someone said to cut spanner in half due to round top and spanner needs to go underneath

Thanks
 
I have recently read something on improving oil supply to where its most needed by fitting a restrictor in the feed to the rocker shafts....Tap the hole for a grub screw that has a 1/16" hile drilled in it, loctite in place.
Comments ?
jp
 
I have recently read something on improving oil supply to where its most needed by fitting a restrictor in the feed to the rocker shafts....Tap the hole for a grub screw that has a 1/16" hile drilled in it, loctite in place.
Comments ?
jp

you could just knock a roll pin the the gallery it would do the same thing, although i would question whether there is any need to do anything on a standard unmodifed engine, after all they seemed to function just fine for the first 50 years
 
Back
Top