Repair panels

1967p6

Member
Hi has anyone got any repair panels that are surplus to requirements, my series one has decided to dissolve itself and I'm trying my best to stick it back together. I'm happily making my own but at this rate it'll take some time to re-build it. plus I'm going deaf from all the tin bashing I'm doing ...tap tap tappety tap..
 
Hi,
On my last spares car I cut out the rear axle mount panels ( complete boot side assemblys) in great unwelded condition.
Still have them if needed, will post picture at weekend if that helps.
Clive.
 
I scrapped off the underseal from mount area found 2 small pin holes around the factory welded seam on the offside.
Cleaned and welded up, it's on the painted one in the picture, what do you think?
Other side not painted.
Most people just cut out what they need to repair as fitting complete panel is not a 5 minute job.
I know!
Just depends on what you want it to look like.
Clive.20170417_145101.jpg 20170417_145110.jpg 20170417_145123.jpg 20170417_145135.jpg 20170417_145230.jpg
 
Hi thanks for the pics. Believe it or not the boot floor and sides are really sound on my car. Its the area around the D posts that are really rotten. Ive re-built the drivers side now. The hockey stick has totally rotted away at the front and the panel behind the lights has severe rot.
 
No problem.
I used the only complete D posts I had on my own NADA rebuild.
May list them on spares section in case
Somebody else needs them.
Clive.
 
Last edited:
Back
Top