Rolling road and carb setup

So I went off to Novatech in slough today and was thoroughly impressed! Andy was a cracking guy talking me through everything he did. Turns out my car was running much too lean so he sorted out the mixture and a couple of runs on the rollers squeezed out 150hp and 210ft lb of torque. I’m very pleased with that given how old it is! I do have a bit of an electrical gremlin surrounding the dizzy cap and or rotor arm. Any suggestions I where to buy those from?
 
So I went off to Novatech in slough today and was thoroughly impressed! Andy was a cracking guy talking me through everything he did. Turns out my car was running much too lean so he sorted out the mixture and a couple of runs on the rollers squeezed out 150hp and 210ft lb of torque. I’m very pleased with that given how old it is! I do have a bit of an electrical gremlin surrounding the dizzy cap and or rotor arm. Any suggestions I where to buy those from?
Distributer doctor google it.
 
Will6440 . Glad you had a good result . I have had 4 cars done at Novatech and have had a good result every time. I would recommend to all members . There are a lot of rolling roads but very few understand Carburettors .
 
Will6440 . Glad you had a good result . I have had 4 cars done at Novatech and have had a good result every time. I would recommend to all members . There are a lot of rolling roads but very few understand Carburettors .
I couldn't agree more Pjim6, I picked him off the back of his website really as most of the cars on there were all carb fed. Glad i've found him now, he did say he was moving premises so keep that in mind if you plan on going back to him.
 
Back
Top