At last night's Worcestershire Meet I was given a pod with the clock and rev counter as i fancy adding a rev counter so I can see what the engine's up to. I need to test it to make sure it works before settling on a price but I'm not sure how it should be wired up. On the back there is a black (I assume earth) with a bullet connector and a green wire without connector both of which attach to connectors on the back of the rev counter with nuts. There's also a braided white with black stripes wire which runs through a "loop" and connector but doesn't appear to be attached permanently. The counter is red lined between 6/7000rpm. Smiths RV1 1000/19 number on it. Not sure if that's a 4cl or 8cyl version but I wouldn't have thought it would matter other than the rev limit may be different?
So now the questions! Is there a wiring diagram for these things? Also would it be easy enough to wire it up temporarily to test it and what should I do? Finally if it works will I have to run extra wires or are they already in the loom (for a 2200SC Auto Series 2)?
Thanks!
So now the questions! Is there a wiring diagram for these things? Also would it be easy enough to wire it up temporarily to test it and what should I do? Finally if it works will I have to run extra wires or are they already in the loom (for a 2200SC Auto Series 2)?
Thanks!