Latest activity

  • G
    Graham2755 replied to the thread P6 V8 recon radiator width?.
    Thanks everyone for the replies. SydneyRoverP6B, your measurements confirmed my radiator seems overly wide. I've attached some pics of...
    • IMG_20210927_203714.jpg
    • IMG_20210927_203931.jpg
  • M
    Good morning to all, i have a 3500 v8 auto, and have a question regarding front brakes. I am sure my front brakes are not fully moving...
  • C
    Chips liked stue1972's post in the thread P6b project.
    Stripped and cleaned the engine bay then 2 coats of epoxy primer and 2 of satin 2k black plus a few suspension components painted
  • C
    Something unimaginable happened today, I sprayed some epoxy on the shell :eek: I gave the underside another light blasting to remove...
  • Thijs Leuven
    Something unimaginable happened today, I sprayed some epoxy on the shell :eek: I gave the underside another light blasting to remove...
  • Tom W
    As for the fuel system and ethanol I made these changes: (1) Replaced any rubber fuel line with ethanol safe hose. (2) Replaced the o...
  • E
    Did you change the forward sun shaft sealing rings? Are you sure all the fluid supply pipes are fitted into the valve body corectly ...
  • sdibbers
    sdibbers replied to the thread 2200tc rough idling when hot.
    As for the fuel system and ethanol I made these changes: (1) Replaced any rubber fuel line with ethanol safe hose. (2) Replaced the o...
  • F
    Flano replied to the thread Front clutch on bw 35 P6 3500.
    not sure aprox 4-5 litres. filled it than ran it through all the gears , dipped and topped up then ran again. And repeated again until...
  • roverp480
    roverp480 replied to the thread P6 V8 recon radiator width?.
    If the radiator end tanks are hard against the base unit, the odds are it will fail in short order as the tubes will expand and try to...
  • M
    mikecoombs replied to the thread Front clutch on bw 35 P6 3500.
    How much fluid did you put in?
  • M
    mikecoombs replied to the thread P6 V8 recon radiator width?.
    A couple of shots of the radiator out of the car would be interesting. it appears in current photo that the core isn't joined to the...
  • jp928
    jp928 replied to the thread P6 V8 recon radiator width?.
    I had a similar problem refitting my rad after a refurb - offside bracket needed some massaging to get the bolt to fit. Its common for...
  • S
    spiritfree replied to the thread 76 Rover P6 3500 project.
    Thanks "harveyp6" - you were right. Eventually managed to prise off the housing & nut but will have to search for a suitable puller to...
  • SydneyRoverP6B
    Hello Graham, I measured my spare which is awaiting a new core, and from the outside edge of each end tank, the distance is 655mm. From...
Top