Recent content by jonboy

ok thanks

Hi all ,i,m looking to rebuild my 3500 engine ,any suggestions where to get parts, pistons ,cam shells ,mains etc, i was thinking rimmer bros or real steel ,what are yours thoughts please John.

ok thanks been trying today to set band but cant get anything to fit, so i,ll have a play tomorrow thanks

Harvey can you tell me what size socket is needed to set the adjuster on rear band please,

Ok thanks can you recommend where to buy a new o ring and filter please

Meant to say I have reset the adjuster

Now I have the servo off can I check rear band and what am I looking for. I have set the adjustment .

Hi Harvey, did.nt get to test drive today, as I had the sump off i checked the filter which was quite dirty also to my horror there was part of a rubber seal in there, so took of rear servo and part of the seal was missing AGAIN ,As you know this had recently been replaced what i thought was a...

Ok thanks going to check level again ,is after selecting all gears as you would on a cold check ,then i,ll go for test drive.

OK Harvey, thanks also , i have a remote cooler which is about 7 x 12 inches which seems big to me ,what do you think

Hi me again, i have altered the throttle linkage so now i have full travel on cable, do you know where roughly oil level should be in box, as i dont know if i have correct length , dip stick as mine is short ,it comes inside the car, as this is in a ford pop hotrod Please

Ok thanks very much for your help. I need to modify my linkage to get more lift.

I have taken up slack in cable ,now i need to modify linkage to get more lift on cable.

this is at rest

Thanks very much for your help ,my kickdown cable is a 16 inch, please can you tell me what cam i have from picture ,this is at full throttle