Recent content by Bert Turnbull

Hi , just so I am clear you say that it’s for a Jag. 5 ltr. And part # c15474 have I got it right? T I A, Bert. Wanaka, NZ.

Have a good Rover Xmas to all, assume cold in Uk,summer here in NZ and warm temps, cheers, Bert Turnbull, Wanaka, NZ.

Hi Folks, my P6 V8 has a small surging when a low speed, not a serious issue, but a pain in the butt, It has been fitted with electronic ignition at some time, any suggestions welcomed an d appreciated, Thanks, Bert Turnbull, Wanaka, NZ.

Oops, should have mentioned it has electronic ignition.

Hi folks, my P6 V8 has a small surging at low speed, any suggestions would be appreciated. T I A, Bert Turnbull, Wanaka, NZ.

Hi, I have just replaced my front wheel bearings on my P6 S, for those who require info, I was able to get TIMKIN set 2 LM11949/10, set 6 LM67048/10, seal Is BI 43945, hope this is of assistance, Bert Turnbull, Wanaka, NZ.

Can anyone advise me of the bearing I’d numbers for both inner and outer fronts on a Rover p6. Preferably SKF or TIMKIN, thanks, Bert Turnbull Wanaka, New Zealand.

sorry I should have written 70 instead of 75, my mistake, thanks, Bert.

Thanks, FYI, my Rover is 3500S being manual, cheers, Bert.

Thanks, you still keep to recommend pressures?

As 185x80x14 are becoming difficult to buy here in New Zealand, will it effect handling etc if change to 185x75x14, thanks, Bert Turnbull.

Hi Ron, it’s original 4 speed manual, thanks, Bert. (New Zealand)

Hi Guys n Gals, can any one advise me of relevant dimensions of rear oil seal p6 V8 gearbox. OD, ID, Depth, I am hopeful that I can have seal on hand at fix time. T I A, Bert.

Hi this colour is called Safron, and was only available in NZ and Aus. they were assembled at the Nelson plant of BLMC. A popular colour at the time for Triumph2.5 and Stags