I have just replaced my inner and outer/inner sills and d posts on my 68 rover p6 ,although I have been told of horror stories with this I had no problems the parts came from JRWwadhamsthey can be found at jrwadhams.co.uk
the panles fitted well with little or no mods
as for the welder i used...
I dont know if it will help I had what sounds like the same prob with my 3500 it turned out to be a loose wire on what appeared to be a cut out switch that had been fited years before this had been fitted to the earth of the coil and as it earthed it cut out ( I DIDNT KNOW IT HAD A CUT OUT...
thanks to all for advice I have spent a nice day working on the brakes ..Found supplier for all my needs locally even had servo repair kit what a bit of luck
all back together now and working :D
the supliers name is Knots green and they are in Walthamstow London e17
regards
Brynn
thank you for your reply I will take note but I think it may be more than that I have spoken to local mechanic he seems to think it might be tha servo does this seem likely
Regards Brynn
HELP !!!!!!!
I have a 1971 3500 and my brakes are not working properly
the peddle goes hard and the brakes seem to fade . I have replaced all the pads and checked the calipers none of wich are siezed the brakes have been blead and the peddle goes to the floor when bleeding so I can rule out...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.