Hi Chris
Many thanks for your very informative reply to my post regarding 'lean' when going round corners, sorry to have taken so long to pass on my appreciation for your help.
Seems like if I fit the upgrades you talked about I will have a superbly handling P6.
thanks
jim
Hi
I am attempting to reduce the 'lean' when cornering in my 3500s and seem to recall some threads regarding an uprated front anti roll bar being offered by classeparts, which they claim transforms the handling. Has anyone fitted one and does it help?
Thanks
Jim
Hi
Thanks to all who posted replies, however Nick suggested Scott's as a possible supplier, am not familiar with that company, any further info?
Thanks
Mexico Brown
Hi Paul
From experience it makes fitting much easier especially where seal goes in at the quarter light and generally helps keep the seal in shape, however with a bit of lubrication the same end can be achieved.
Mexico Brown
Hi
Re earlier post can confirm Classics car magazine does have full article on renewing vinyl roof on P6, goes through all the steps from start to finish, very helpful as it has all the pics as well.
Mexico Brown
Hi
Thanks for reply, decided to get roof done professionally, my skills don't stretch to doing roof, hopefully all will go well. What a wealth of information is on this forum, must remember for future should the need arise.
Mexico Brown
Hi Pinkie
Ta for info, went to website and viewed samples, I notice most 'roofs' have seams, which is 'correct' for P6 with or without seams?
Mexico Brown
Hi have another question re covering roof of my P6 with vinyl, quattro mentioned Leyland or Ford pattern. For the uninitiated like me can you explain difference between the two?
Thanks
Mexico Brown
Thanks guys for info, will proceed accordingly. Roof now ready to lift off, decided to go the route of leaving back window/seal in place, just hope refitting will be ok, fingers crossed
Mexico Brown
Hi am about to get my roof covered with vinyl and upholsterer who is doing the job states there is difficulty in getting material the width of the roof and as such it can't be covered with one piece. From my limited knowledge roof should be 'done' in one piece. Can someone confirm please...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.