Recent content by OZIP6B

Welcome to the forum, nice P6. interesting bonnet scoop :) I've got one as well but a bit more period correct. Its from our XY GT's with a number of modifications to make it fit correctly.

Does anyone have a current contact email address for Fosseway? I seem to have no response from the email provided on their website.

The fan is fitted and works perfectly, during this summer we have had 40+ degree days and the water temp has not climbed past 82 degrees.

lol... like a jet plane :-) ive heared a lot worse. I thinlk I'll have about 1mm clearance which is good enough for me... yeah its slightly overkill as an auxillery but at least it half ready for an electric water pump conversion and i love the sound of a large fan. I'll have to upgrade the...

I got the same fan, it fits perfecty, excellent write up, my fan unit is only as an auxillery not a main fan, I'm keeping the clutched fan for the moment, in the near future I'll intstall an electric water pump and controller. Here is my fans first test run set at the lowest level on the fan...

A small but important upgrade to the cooIing sysytem. I installed a Spal VA18-AP51-C41S 16" pusher fan and Davies Craig Digital fan controller.ling systen. Reading PeterZRH "my cooling project" was very informative and detailed, exactly what I needed. I took a slighly different approach with...

Last summer, even with a new 3 core radiator ran a little hot during the day but never ran into the red... I've just installed a the SPAL 16" Pusher fan along with a Davies Craig digital fan controller as a back up for the coming summer just to be safe.

Love the wheels, are they an off the shelf item or where they custom made?

I'm thinking of doing a similar installation, how do you find the SPAL fan? is it annoying loud when its on?

Fuel system upgrade is next on the list of things to do, on long full throttle acceleration it would run out fuel at the carbs, I have decided to uprade the electric fuel pump to a "Facet Fuel Pump 6.5-7.5psi 45gph Red Top" and install a Holley 1-4psi fuel pressure regulator and guage.

Thanks Guys, Its been a long road, time is very limited at the moment. After i installed everything i went over it all to check clearance and pedal pressure and found a a couple of issues, firstly the supplied bearing carrier was far to shrort, i had it replaced with a longer unit. Secondly...

The seats are back in along with the centre console, I'm very happy with the result :D

Hi Mark, Being from Australia, the only place I could source a carpet set was from All Car Capets, excellent service and product but i think their templates are a little out, most sections did not fit properly and it required a fair amount of trimming etc.

Whislt waiting of more parts to arrive, I decided to install a carpet set I purchased a while ago, the fitment is passable. If i had to do it again, I would probably have a carpet set sent over form England, our local ones are not the best fit. Some sections turned out perfert whislst other did...

Thanks mate, it nearly ready for the road, just waiting for a few bits and pieces to complete the the conversion. Its been a long time coming, just hard to find time these days.