PeterZRH's latest activity
-
PPeterZRH replied to the thread ZF 4HP22 step by step..I do tend to boot it to activate the kick down. Maybe I need to be a bit more gentle...
-
PPeterZRH replied to the thread ZF 4HP22 step by step..I didn't install it. So basically, it is too slack? Could the crimp move or the cable stretch perhaps?
-
PPeterZRH replied to the thread Trying to reach Andy Morgan (eightofthem).PM you...
-
PAnyone seen/heard from him lately? I emailed him some weeks ago and messaged him. No reply so far. Thanks, Peter.
-
PPeterZRH replied to the thread ZF 4HP22 step by step..One the plus side I can vouch for Andy's skills. 12000mile and 6-7 years in the fluid is as as new, no smells, no particles, no leaks.
-
PPeterZRH replied to the thread ZF 4HP22 step by step..Hi all, anyone spoken to Andy (@eightofthem) lately. I tried emailing a few weeks ago and I PM'd him here over the weekend...
-
-
PThis is all long term thinking stuff. Well....I guess replacing the plastic spacer in the passenger footwell with a piece of ply will...
-
PI thought JP was wondering where to put the loom, not the controller. Mine is actually under the passenger seat, although I nearly put...
-
PPeterZRH replied to the thread Fuel Injected fun....The 14CUX ain't exactly big. I'm not sure what the problem is. If it didn't fit on the A-pillar then it could certainly fit in the...
-
PPeterZRH replied to the thread Steering box adjustment and lubrication.If you over tighten them it will damage the box quite quickly. You'll notice the steering wont self-centre. EP90 will nicely remove...
-
PManual steering boxes usually take a 90EP oil. Take care not to over tighten adjustment, and make sure you can get full lock in both...
-
PPeterZRH replied to the thread 1971 P6 2000 Series 2.Has the mechanism failed or does it simply need tightening i.e more twist in the torsion bar? And the mechanism and basic frames are...
-
PPeterZRH replied to the thread Has anyone used MEV Spares in Marsden, Kent who are also on eBay as jumble master for new front Brake imperial calipers?.Reconditioned original calipers are far better than new as they are stainless lined. In principle in practical terms they'll last...
-
PPeterZRH replied to the thread Electronic ignition module in my P6.The main challenge for ignition is actually at the higher end of the rev range. Mechanical points can bounce and the charge time for...
-
PPeterZRH replied to the thread Electronic ignition module in my P6.If the points ignition is in optimum condition it'll make no difference at all. The point being points ignition doesn't STAY in optimal...
