Thanks for the replies I have now taken the servo apart and I now know it is a power tune type all looked new inside diaphragms were good the air valve piston took a lot of pressure to release.
Now silly question before I put it all back on the car should the air valve assembly be on the top...
Checked the air admittance valve cleaned and stretched the spring still the same I have a brake warning light on now and the brakes seem to be locking on and not releasing its like driving off with handbrake on.
Hi All Looking for wisdom again
My 2200TC has a brake/Vacuum issue.
I have the warning coming on light sometimes also when braking first press of pedal seems to give a ok stopping force press the brakes again and I could stop on a dime the pedal seams to get harder and little force required to...
Im about to lose the will to live
I have just brought a 2200 which was running rough and when hot ran at 3000RPM
I replaced the jets needles and float valves the car would run for a while and just as I start to balance the car would not start again now sometime the fuel filters would be empty so...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.