Search results

Hi All, I have looked at the threads on here regarding the shims and tappets and now looked at the photo's in the Haynes manual. This may be a daft question but I'm assuming that these shims allow the valve to open fully. If the valve has receded into the cylinder through general wear and tear...

Hi All, I have noticed in some photos that some P6's are fitted with a badge bar, was this a Rover accessory as they look like they clamp onto the bumper whereas the ones on E bay require drilling.? I quite like my car badges so will be wanting to fit a bar and a clamp on is less likely to...

Hi All, I've seen from other posts that the tappet adjustment on the Rover is by using shims of different sizes. When I've collected my P6 2200sc auto I will need to be looking at checking and adjusting and shims. I'm not sure if I will risk doing the work myself until I've taken a look, but I...

Hi All, Just purchased my P6 and she will need to have some anti-freeze put in her. My Standard 8 could only use a particular type to avoid severe corrosion, is this the same with the Rover and if so what type/make should I be getting? Regards John

Hello everyone, I'm new on here, haven't got my Rover yet but hope to soon I'm looking for a 2200sc automatic for touring and weekend use and hope to be a proud owner in the near future! Regards John