Search results

Rover P6 3500 for sale - http://i.ebayimg.com/00/s/MTIwMFgxNjAw/z/X2sAAOSwFqJWr2XX/$_57.JPG Due to a change of circumstances I have been left with little choice other than to sell the Rover P6. I have done quite a lot to the car, it now drives, stops and steers. The car is on ebay, I am not...

Hi, Could anyone recommend a welder. The sills and castle rails passenger and drivers floor panel needs repair. Can deliver the car but don't want to take it too far, or is there a mobile welder that anyone could recommend. Ryan

Hi, I am currently restoring a 1972 P6 and the body of the car is in a very bad way, for example I can't jack it up without pushing up through the floor event with the square foot of plywood between the jack and car. I am looking into the cost of welding against the cost of moving all the car...

Hi, I have found that my fuel pump (mechanical) is not working as it should. I have purchased a kit to put it right but I didn't realise there was a 19mm diameter NRV and a 23mm NRV. Just my look that I need the 23mm and I have the 19mm. is it possible to get the correct 23mm NRVs from...

Hi, This must be such a simple question but I simply don't know which line is which on the fuel tank. There's one on its own (is this the main fuel line) then there's two joined together (are these the reserve and return fuel lines)? Any help would be great, I am pretty sure my pump is faulty...

Hi, I am new to the Rovers I have been restoring Flying Standards for a couple of years and now I have some how moved to Rovers. A pretty good move. I have a 1937 Rover 16 never needed an MOT so it's completely original as it was when it left production. I also have a Rover P6 V8 which was...