Search results

Following on from my post on SU HIF6 carbs (weak running at around 3000rpm and then possible a worn camshaft) as a test on the running engine I removed each spark plug lead individually, then replaced and noted on the first two cylinders I tried that this created a slight misfire but the engine...

Hello everyone, Having read some recent posts on fused supplies for a Kenlowe electric fan installation I've check mine to discover that it's taken directly from the battery +ve and not fused. Can anybody advise as to what rating of in-line fuse I should install. Cheers, Rob

Hi all, I'm having problems setting up the twin SU HIF6 carbs on my Rover P6 V8 engine. The car drives fine when cold on choke but when warmed up it's reluctant to pull above 3000 rpm. Pulling out the choke again at this point and the car runs fine suggesting its running too weak? However no...

My 1973 P6 V8 was fitted with an Accuspark electronic ignition module replacing the points and condensor in the original distributor. This module failed and I replaced it with an identical Accuspark unit and it appears that the replacement has now failed! Can anybody recommend a reliable make of...

I'm having problems starting my 1973 P6 V8. When turning the ignition key the starter motors fails to engage and after about 4 attempts or so of turning the ignition key off and then on again it engages, turns the engine over and it starts. The solenoid appears to be working okay as it is not...