Search results

Thank you,I will make Thanks for your reply, I'll ensure the torque converter bolts are torque properly. I have seen some of the replacements that have spokes, can only see the solid ones for sale as used options (which is a route I might go down). Thank you, but am in England so not very...

Thank you very much, will look into that

Hello all, Just got in after a breakdown and a speedy recovery from the good old AA and was wondering if anyone could help before I get stuck in working on the car this week. I have a 1968 2000 Automatic. This morning as I set off there would be the occasional crunching noise. It would...

I think wet looking sender is just waxoyl type stuff reflecting, the liquid on the caliper is definitely brake fluid. Am not 100% quite what you mean Phil. From what I have seen the pad touches all of the disk

Thanks Harvey. Will get looking for a rebuild kit and get the calipers off. Thanks. If anybody has any recommendations for good suppliers for rebuild kits then advice would be much appreciated. I am on a limited budget and am currently eyeing up the kits on MGBD parts and ebay suppliers

Have had a good inspection under the car and have attached a couple of pics. NS caliper looks like it has been replaced at some point OS caliper looks much older and has some brake fluid drops on it NS and OS pads show a strange wear and are much thinner towards the bottom Discs have a fair bit...

That was my suspicion, I can do tomorrow. Cheers!

Hello All! I have recently purchased my 2000sc and I have found that despite both front brakes being fine, the handbrake and both rear brakes are do not work at all. They do not cause any drag when the brake is pushed. I know the car was sat without being driven for at least 1 year before I...