Search results

I'm looking for a good pair of 3500S exhaust manifolds if anyone can help please pm me - thanks

I got big problem!! Just assembled my 4.6 bottom end, new bearings, new rings etc . Refitted p6 timing cover, and sump (yes I did give it a clout to ensure clearance on front conrods!). Then turned it on the front pulley with extention bar to listen for any nasty noises etc. Erm, not good, turns...

I'm refitting the timing cover having rebuilt the motor (4.6 yey), is it only the rope gasket that seals the crank at the timing cover hole? thanks Andrew

Hi, Im converting my 3500 4 speed to lt77, I'm using sd1 slave cylinder so I need to have a new hose made. I think I need 3/8 one end and 7/16 on other. Can anyone confirm this? Thanks ,Andrew

Can anyone point me in the right direction as what to try next, basically my front n/s caliper has been locking on, I naturally assumed that it was the caliper itself therefore replaced it with a reconditioned unit. However it is still doing it, so I replaced the hose and checked there is no...

Looking for front n/s caliper in good working order ready to fit. I rebuilt mine with new seals etc and its still leaking + binding!! So if anyone has one that has just been removed I would be interested. Thankyou.

LOOKING FOR TIDY PAIR OF DOWNPIPES FOR V8S (LARGER BORE), BEFORE I BUY NEW!! THANKS ANDREW

Im looking for a COMPLETE dizzy (to include vacuum advance mechanism!) cheers

Right, the 3.9 is pretty much ready to be fired up, having fitted the p6 timing cover but not sure if I have circulation of oil. I have packed the oil pump gears with petrolium jelly and cranked her over with plugs removed. I assume the only way of telling is if oil reaches the rocker gear which...

Dont know if anyone can help.... I need exhaust system for 3500s, I have the manifolds and downpipes. Or my other option is to find tubular manifolds (correct fitting ones!), then have exhaust made up. Thanks

OK Probably sound a bit thick now but having converted my 3500 auto to manual I failed to get the starter to turn - then remembered the inhibitor switch. I joined the wires together and it now wont stop turning! Even after taking the key out of the ignition. Ive obviously done it wrong. What is...

Ok I probably sound a bit silly now, but converting auto to manual etc, gearbox + master cylinder fitted, went to refit prop only to find that its about 9" short!! Didnt realise that the prop is longer. Has anyone got a 3500s prop available? Do I need the complete prop or just the front half? Help

WANTED , looking for a manual pedal box for a 3500s , clutch master cylinder and linkages in working or servicable condition. Needed for conversion from auto. Please send a message or phone me on 07772 597505. thanks Andrew

I have for sale a 3.5 from my 1973 P6 auto. Im fitting 3.9 manual hence surplus and in my way to be honest! Only done 47K with paperwork to prove, no problems, ran nicely, minus front cover/water pump (needed for my 3.9) could do with new timing chain. Offers invited. Located in Fishguard ...

I have for sale a BW35 which has done 49k, I paid a lot of money for this which I probably wont recoup! Im converting to manual hence its sale. Ill have some photos later in week. Any questions please contact me This is for a 3500 V8

Im fitting a 3.9 into my p6 instead of the 3.5. Cant really see any problem there. I aquired a pair of 2" SU's from a jag. 2 problems: when fitting in a V formation the linkages dont meet on the same side! Any ideas? Home made linkage perhaps. Secondly, theyre too tall! The bonnet will not...