Can anybody advise me were I can purchase front spoilers There were some on ebay a couple of months ago but they have seem to disappear any help will be appreciated.
Bob
Good evening to everyone,
I am hoping somebody out there might know the owner of the above.I have a Kent Police Traffic car which I am restoring and would like to know what make and model of the police radio and also where he purchased the calibrated speedo in its cowl I hope somebody out there...
rover s part number for the calibrated speedo is 586545 and this fitted into a pod. the Met calibrated speedo was a lot larger and sat in a metal frame like in the U tube clip.I am after the smalle one that fits into a pod.I hope this clears things uo. Regards Bob
Can anybody help!! I require the silver push button on the side of the et headrest Can any body let me know were I can find a replacement.
happy Rovering
Bob :D
Hi There
Iam still after the above nobody seems to have a good one.I have found a Series 1 2000 will this fit and also will the trim fit on the lip of the bonnet.Can any body advise.
regards to all
Bob :lol:
The way it was put together like this
371169 rubber boot 593617 is first then 591478 fits in to the rubber boot fit gear stick though placing the plastic bush into the cut out then place 591985 and bolt it up?
is this correct
The way it was put together like this
371169 rubber boot 593617 is first then 591478 fits in to the rubber boot fit gear stick though placing the plastic bush into the cut out then place 591985 and bolt it up?
is this correct
The plot thickens,I have replaced the new bush and pin on the gear stick much better placed everything back together but still have a floppy gear stick The only thing I can think of is that there must be a bush that fits onto the dome end of the gear stick and into the gear select rod.Is this...
Thank you Harvey p6 for your help.I have ordered a new bush but I am not sure if it comes with a new pin.I would be most grateful if you could supply the pin you have.How much would you like for it ? I am very keen to get the p6 back on the road again.Thanks again for your time.
regards
Bob
Thanks every one for your helpful replies I have now taken out the gear stick and the problem was the plastic bush.On there is a ball bearing when you push it it goes into the bush.On the gear stick there is a grove is this were it slots into body Does this lock the bush into place? Can any...
Hi There,
Can anybody help me.I have a 1974 3500s and the gear stick will not select any gears and is very floppy.Could it be the gear selection bush?The gears have been fine one minute it was working the next nothing.Thanks for the help.
Hi There,
Does any body know where the above is.I have checked the dvla site and it seems to be off the road since 1984.very intrested in purchaing it as it usr to be a ex kent police car Can any body help regards Bob
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.