J.Lackland
New Member
During the past year and a half I’ve found help with every problem I’ve had on my -75 2200TC
in this invaluable forum, but couldn't find any post covering this one. Help much appreciated.
I am about to replace the diff mounting bushes on my ’75 2200 starting with the rear pair.
As the original bushes aren’t available, my supplier sent me a set for the P6B.
First question:
The confusing bit is which way to put upwards – the larger section or the thinner, tapered one?
Strangely enough the best fit was had with the larger section downwards– but can this be right?
In the pictures the old bush is on the left.
The first one shows the way I hope it is to be fitted :roll: .
The second pic’ shows the new bush turned downwards, the way it sat when I got the “best fit”
as mentioned above :?
Second question:
The Haynes manual doesn’t mention torque settings for these bushes, does anyone know the values
for the centre support nut/bolt and the two nuts/bolts securing the bush to the body?
Cheers // Johan
in this invaluable forum, but couldn't find any post covering this one. Help much appreciated.
I am about to replace the diff mounting bushes on my ’75 2200 starting with the rear pair.
As the original bushes aren’t available, my supplier sent me a set for the P6B.
First question:
The confusing bit is which way to put upwards – the larger section or the thinner, tapered one?
Strangely enough the best fit was had with the larger section downwards– but can this be right?
In the pictures the old bush is on the left.
The first one shows the way I hope it is to be fitted :roll: .
The second pic’ shows the new bush turned downwards, the way it sat when I got the “best fit”
as mentioned above :?
Second question:
The Haynes manual doesn’t mention torque settings for these bushes, does anyone know the values
for the centre support nut/bolt and the two nuts/bolts securing the bush to the body?
Cheers // Johan