Fitting a rev counter

[pdcharlie]

Does anyone out there know if it is possible to fit a rev counter to my 2000 sc ( '67 ) and if so where do u pick up the feed from / wire it in ?

Thanks V much

Paul

 

[Demetris]

If you fit the original rev counter then you have to pass the wire that goes from the distributor to the coil through the rev counter. Also you will need a live feed and earth. Perhaps the wiring is already fitted by the factory, you should check this. Also be sure that the polarity of the rev counter that you are going to fit is the same with your vehicle.

If you fit an aftermarket modern one (your vehicle has to be negative earth for this) then you need a feed from the coil negative, a live feed from the battery (preferably live only with the ignition switch on), and an earth.

Demetris

 

[P6Disease]

The wiring for the optional rev counter is a seperate harness.

Roly.