Fitting windscreen - Everything in its right place

B

BBLongman

New Member
Anyone got any idea if I have got the front windscreen seal and supports fitted correctly.

Should the seal sit outside the roof panel? I presume it will be the same on a saloon as the estate.

Have I got the correct bits of the seal on the outside of base unit? I.e the stainless trim will go over on lip and under another.

Do the support jacks and bottom rail look right?

(You'll never strip a car down and wish you'd taken fewer pictures to remind yourself how it went together!)

Thanks

BB

1.JPG

2.JPG
3.JPG
 
Hi Bennet,

See my email to your estate restoration email address about the roof and rubber seal.

Your outer windscreen jack looks exactly correct. I cannot see the centre windscreen clamp in your photo. (See picture 2RC 678 in item 76.81.01 in the Rover Repair Operation Manual.)

Regards,

John
 
Thanks John,

No email at website address. Could you resend to BBLongman at yahoo.co.uk

Sounds like the rover repair manual could be quite useful.

Bennet
 
You must log in or register to reply here.
Back
Top