J.Lackland
New Member
Just removed and dismantled the brake master cylinder in my 2200TC fitted with the dual circuit brake system. During dismantling a lone dished washer suddenly appeared. Stupidly I had failed to notice what part it had been attached to. I didn't see it until after removing the tipping valve for the primary fluid port, and withdrawn both the first and secondary plungers, but before dismantling the valve at the front of the secondary plunger.
In the picture it lies just above the tip of the little screwdriver, and no, it is not the washer at the tip of the secondary plunger, controlling the centre valve fluid port.
Help would be much appreciated, as I've quite obviously bungled the whole job.
In the picture it lies just above the tip of the little screwdriver, and no, it is not the washer at the tip of the secondary plunger, controlling the centre valve fluid port.
Help would be much appreciated, as I've quite obviously bungled the whole job.
Last edited: