Still fiddling with the electrics of my P6 3500 auto. And managed to tackle most of the issues. Next one comes up.
the choke warning light.
Today I found out I have a 2 carb manifold without the otter switch. It has the triangle shape where normally the otterswitch is mounted but mine is not prepared for the otter switch
so I was wondering if there are other possibilities to get the choke warning light to do were it is supposed to do.
e.g. can I connect it to the thermostat together with the wire for my temp gauge or will it short cut my temp gauge.
Last option would be drill holes for the otter switch, because the manifold is not flat enough to make a water tight seal when the otter switch is mounted.
the choke warning light.
Today I found out I have a 2 carb manifold without the otter switch. It has the triangle shape where normally the otterswitch is mounted but mine is not prepared for the otter switch
so I was wondering if there are other possibilities to get the choke warning light to do were it is supposed to do.
e.g. can I connect it to the thermostat together with the wire for my temp gauge or will it short cut my temp gauge.
Last option would be drill holes for the otter switch, because the manifold is not flat enough to make a water tight seal when the otter switch is mounted.