Overhaul waterpump

[Hans]

Hi , have somebody overhauled the waterpump ?
I dismantel the pully by heating and a puller.
I was thinking the pumpshaft go in the direction from impeller with plastic hammer and after that between the innerside of pumpcase disassy the ball bearing, but no removing from shaft into ball bearing.
Somebody advice ?

 

[Hans]

I look tommorow but i think the metal i see is a gasket and not the bearing , maybe behind the gasket there is an springwasher , it must be, because the rotor must be axial locked. ooh when i read this it is not good english :evil:

 

[Pilkie]

Its probably quicker and easier just to replace it,as getting all the parts you need to overhaul it could be a problem!

 

[Hans]

Yes, i looked this evening , the balls are rolling in the shaft , so i think no overhaul but scrap it.