webmaster
New Member
In my quest for good, cheap wheels that will work on the P6, I've been thinking about Porsche rims, especially after seeing a set of 17" Boxster rims for £150 on ebay.
Now the P6 PCD is 5 * 127mm and the Porsche PCD is 5 * 130mm, so effectively only 1.5mm per wheel stud.
I'm wondering whether the bolt holes could be offset-drilled to correct them for 127mm and then just use nuts with adequate taper washers. (most alloy nuts are like this anyway).
I wonder if anybody has an opinion on this (Chris ?)
Of course I haven't even considered offset or centre bore yet, but hey ho !
Now the P6 PCD is 5 * 127mm and the Porsche PCD is 5 * 130mm, so effectively only 1.5mm per wheel stud.
I'm wondering whether the bolt holes could be offset-drilled to correct them for 127mm and then just use nuts with adequate taper washers. (most alloy nuts are like this anyway).
I wonder if anybody has an opinion on this (Chris ?)
Of course I haven't even considered offset or centre bore yet, but hey ho !