rear panel

H

Hans

New Member
Hi , sombody know the screws who fitted the rear panel (nr:362707) into clips(nr78678) are selftappers or unf bolts, i have both but i have also parts from my donor car and don't know wich i need.
 
The rear valance screws are 367207 and the nut plates are as you say, 78678.
They are philips head UNF screws. I'm not sure of the size but I can find out if you need to know.
 
Replace them with close to original looking stainless steel items and washers,as they do get very wet,and old ones are prone to seizing up!
 
I used hex head panel screws, with a discrete brown finish, but they stand a bit proud and, :roll: needless to say, I've chipped the bottom edge of the bootlid by slamming it. So I'll be looking for the proper ones, thanks for the tips chaps.
 
mrtask said:
I used hex head panel screws, with a discrete brown finish, but they stand a bit proud and, :roll: needless to say, I've chipped the bottom edge of the bootlid by slamming it. So I'll be looking for the proper ones, thanks for the tips chaps.
Click to expand...

If you have to slam it,its adjusted wrong! :wink:
Drop the bootlid from about 6" height and it should close easily!
Ive got s/s hex heads with spire threads,for ease of removal if needed,and my bootlid lip is about 5mm from them and will not get any closer even if I do slam it!
 
Fit of anger I'm afraid. Temper temper. Something to do with the blather about "not my fault" I was being subjected to at that moment, regarding my paintjob, caused me to use a mite too much force for dramatic effect. That'll teach me to be dramatic.
 
You must log in or register to reply here.
Back
Top