wayne champion
Member
hi all got a few jobs that need doing but being new to p6 ownership i was hoping those in the know could help.
1. the rear scuttle panel by boot lid, i noticed a puddle of water by the boot hinge then noticed the seal has a big gap either side, but the middle of the seal sits firmly against the rear window, is this a design fault or has somebody fitted an after market seal at some stage, if the later are there ones out there that are proven to fit better. how would i go about removing the scuttle panel so that i can get a good coating of wax oil under there.
2. the car has had a repair done to the rear door at some stage however they did not shape the bottom correctly,i can put this right but when done i would like to lower the front door to get a better gap between the panels, how would i go about adjusting the height of the door, thanks in advance wayne
1. the rear scuttle panel by boot lid, i noticed a puddle of water by the boot hinge then noticed the seal has a big gap either side, but the middle of the seal sits firmly against the rear window, is this a design fault or has somebody fitted an after market seal at some stage, if the later are there ones out there that are proven to fit better. how would i go about removing the scuttle panel so that i can get a good coating of wax oil under there.
2. the car has had a repair done to the rear door at some stage however they did not shape the bottom correctly,i can put this right but when done i would like to lower the front door to get a better gap between the panels, how would i go about adjusting the height of the door, thanks in advance wayne