So Cal V8
Active Member
Mike,
Yes! Much better to see the car go to good use instead of being binned.
I have one of the rear window stops pulled and put to one side for you - I will try to get to the other side today (maybe), but I need to move the car to be able to open the door.
It is an A/C car and you are more than welcome to the bulkhead. The boot has already been cut out and sent to New Jersey to find a new life in SDibbers' car, so the floor forward is all still intact. Can you get me a photo of the two areas in question and mark up what you want cut? I would also look into estimated freight costs if I were you - I hope they don't want stupid money as I want to see these bits put to use.
I am learning my way around the Plasma cutter, so my cuts aren't always pretty. The unit is a cheap Chinese unit, but it gets pretty good reviews online - $230 from Amazon - plus $20 for extra consumables. The metal is dirty - surface rust, undercoat, paint. etc. so sometimes it's not easy to strike an arc - although it is much easier when you don't forget the ground clamp!
It's not going to be cut up quickly, but I hope to make steady progress as I want the space back to get to work on the Wild Rover.
I'll post some photos later.
Yes! Much better to see the car go to good use instead of being binned.
I have one of the rear window stops pulled and put to one side for you - I will try to get to the other side today (maybe), but I need to move the car to be able to open the door.
It is an A/C car and you are more than welcome to the bulkhead. The boot has already been cut out and sent to New Jersey to find a new life in SDibbers' car, so the floor forward is all still intact. Can you get me a photo of the two areas in question and mark up what you want cut? I would also look into estimated freight costs if I were you - I hope they don't want stupid money as I want to see these bits put to use.
I am learning my way around the Plasma cutter, so my cuts aren't always pretty. The unit is a cheap Chinese unit, but it gets pretty good reviews online - $230 from Amazon - plus $20 for extra consumables. The metal is dirty - surface rust, undercoat, paint. etc. so sometimes it's not easy to strike an arc - although it is much easier when you don't forget the ground clamp!
It's not going to be cut up quickly, but I hope to make steady progress as I want the space back to get to work on the Wild Rover.
I'll post some photos later.