Squashed Nose
New Member
I'm a little confused.
I'm looking to repair the sill(s) in my 1971 3500 auto. The Rover manual doesn't show an inner sill as such, presumeably because it is an integral part if the side frame. It then shows two channels, one running from the A post to the B post and a second running from the B post to the C.
However, when I went into Wadhams site, it shows two repair panels, both of which run from the A post straight to the C post (with the cover on top).
Now I don't know which sections I need. The rust on mine is where the sill meets the floor and wheel arches, front and back.
On another point, the manual makes a point of showing the rear jacking point three times but makes no mention of the front, only the tubes, into which one fits a 22mm steel rod.
So where is the front jacking point?
I'm looking to repair the sill(s) in my 1971 3500 auto. The Rover manual doesn't show an inner sill as such, presumeably because it is an integral part if the side frame. It then shows two channels, one running from the A post to the B post and a second running from the B post to the C.
However, when I went into Wadhams site, it shows two repair panels, both of which run from the A post straight to the C post (with the cover on top).
Now I don't know which sections I need. The rust on mine is where the sill meets the floor and wheel arches, front and back.
On another point, the manual makes a point of showing the rear jacking point three times but makes no mention of the front, only the tubes, into which one fits a 22mm steel rod.
So where is the front jacking point?