V8 cable wiper mechanism.

F

Fraserp6

Member
Pretty much what the title says, after a cable wiper set up so that I can avoid clattering into the NADA heater box.

Cheers

Fraser
 
Hi Fraser

I believe I have what you need!! Let me know a bit more info as I have one with cable drive and one with bar style drive. I can take a photo if you wish. It's complete with motor etc.

cheers jamie
 
I'm basically looking to change over the the current Rod and Bar system to a cable system, as the NADA heater box is now in the way.

I don't have a workshop manual to had just now, so I don't know how much is interchangeable, however, I'm probably looking to replace the whole lot.

A photo would be ideal.

Fraser
 
I was under the impression that the difficult bit was the mounting set up for the cable wiper motor to go where no motor had been before. I know the rubber bobbins it sits on are quite hard to come by - and i can't see them in the parts manual either! I think I have a couple of the new fibreboard heat shields somewhere. Here is the whole assembly on Ian's website:

http://www.rover-classics.co.uk/ima...v8/electrical/pages/Wiper Mechanism 3_jpg.htm

Chris
 
P080610_1913.jpg

just found this lot in a box in my garage. Any use to you??
 
Hi Fraser

I'm gradually turning out all my S2 bits. Latest out of the box is a NOS wiper motor shield part no 370602.

pm if you'd like it.

Chris
 
You must log in or register to reply here.
Back
Top