Barten
Active Member
Hi, I plan to install the windscreen on friday. When I unpacked the brackets these 2 rubber blocks (appr 2x1x1 cm) was together with them and I had written "place one on each side" . It was hard to read after 25 years in storage. I have an idea that they are for keeping the correct distance for the screen but don know for sure and I have not found any mentioning about it in the workshop manual. Do anyone know if they are necessary and if so where to put the ? Another question : You can the the foam seal just above the channel in the Picture. This foam seal I have glued all the way for the windscreen, but for the rear screen, there is only a piece appr. the same length as the metal channel. Is this correct? That way there will be some extra air escaping at the rear.
Regards, Barten
Regards, Barten