Lovel
Member
I'm currently installing a new front screen and seal (old screen delaminating and old seal was perished) and I am having difficulty obtaining a good fit in the top corners where the stainless finishers meet the screen rubber. Does anyone have any solutions to improve upon the fit? Iv'e read a few posts on here that have had the same issue as mine.
If it were possible to fit the rubber seal before the glass? I would be almost tempted to hold the seal in place in each corner via 1 or 2 self tapping screws driven into the inner screen channel. :shock:
If it were possible to fit the rubber seal before the glass? I would be almost tempted to hold the seal in place in each corner via 1 or 2 self tapping screws driven into the inner screen channel. :shock: