Recent content by Trickie

Thank you for the replies, I have found the nipple and fitted the pipe. Tt was quite a stretch as the pipe is a bit short which probably explains why I didn't look there before.

I have had to remove the carburettors on my 1975 2200TC to cure a petrol leak and now, having putting them back I have a pipe which I don't know where it goes. It is the small pipe that Tees off the brake servo vacuum pipe. Any ideas? Thanks Richard

I managed to drill out both sides OK, I used a spotting drill to start a centre and then drilled out in stages until all the rust had gone. I fitted the rubber bushes without much of a problem, I turned a pin to fit in the 3/16" outer hole and used a couple of screwdrivers to compress the...

Thanks for the replies, I will try drilling it out.

On my 1975 2200TC I received and advisory on its last MOT of worn front lower shock absorber bushes. I have bought some new bushes but when I removed the shock I realised that the split pin was in the outer vertical hole. When I removed the bushes and shock I realised the inner, horizontal...