Thank you for the replies, I have found the nipple and fitted the pipe. Tt was quite a stretch as the pipe is a bit short which probably explains why I didn't look there before.
I have had to remove the carburettors on my 1975 2200TC to cure a petrol leak and now, having putting them back I have a pipe which I don't know where it goes. It is the small pipe that Tees off the brake servo vacuum pipe. Any ideas?
Thanks
Richard
I managed to drill out both sides OK, I used a spotting drill to start a centre and then drilled out in stages until all the rust had gone. I fitted the rubber bushes without much of a problem, I turned a pin to fit in the 3/16" outer hole and used a couple of screwdrivers to compress the...
On my 1975 2200TC I received and advisory on its last MOT of worn front lower shock absorber bushes. I have bought some new bushes but when I removed the shock I realised that the split pin was in the outer vertical hole. When I removed the bushes and shock I realised the inner, horizontal...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.