Ban306
Active Member
Hi all, I decided to go for a run in the 2000 but couldn't even get the car off the driveway
as it had hardly any clutch and when I did mange to get it into gear I nearly shot through the garage door
lucky the cat was out of the way.
On inspection the Slave Cylinder was leaking fluid out of the Rubber I tried bleeding it but it was still leaking.
I ordered a brand new one and went to fit it, the old one was full of water and fluid and rust no wonder it was not working.
But I now have a second problem with the master cylinder bowl it wont empty the fluid
I have tried putting a thin rod where the pipe connects and going in and out but nothing so I am going to have to remove it
Unless someone can suggest something maybe theirs a bit of rubbish in there.
There are two bolts that I can undo and as I pulled the master out there is a rubber on the rear do I just take off the rubber
and is there a clip holding it on I am not to sure how you remove the master.
Any help most welcome Thank you
as it had hardly any clutch and when I did mange to get it into gear I nearly shot through the garage door
lucky the cat was out of the way.
On inspection the Slave Cylinder was leaking fluid out of the Rubber I tried bleeding it but it was still leaking.
I ordered a brand new one and went to fit it, the old one was full of water and fluid and rust no wonder it was not working.
But I now have a second problem with the master cylinder bowl it wont empty the fluid
I have tried putting a thin rod where the pipe connects and going in and out but nothing so I am going to have to remove it
Unless someone can suggest something maybe theirs a bit of rubbish in there.
There are two bolts that I can undo and as I pulled the master out there is a rubber on the rear do I just take off the rubber
and is there a clip holding it on I am not to sure how you remove the master.
Any help most welcome Thank you