webmaster
New Member
As many of you may remember, I'm working on a new coupe / convertible project following the death of my original convertible due to terminal rot.
It's been pretty slow going this year with not a lot of work done other than trying to finalise the shape of the drivers side door / rear wing.
Anyway, today I managed to turn the car around so I can start on the passenger side. Quite fun as I rolled the car out of the garage, jacked it up in the centre, spun it round on the jack, then rolled it back into the garage.
Now it just looks like a standard P6 again. Time to break out the spot weld drill......
Interestingly I've had some emails from Rob Mellaart in Holland, he's been working on a coupe project, but is considering making a convertible instead, here's a couple of photo's he sent me.
Edited By webmaster on 1199039379
It's been pretty slow going this year with not a lot of work done other than trying to finalise the shape of the drivers side door / rear wing.
Anyway, today I managed to turn the car around so I can start on the passenger side. Quite fun as I rolled the car out of the garage, jacked it up in the centre, spun it round on the jack, then rolled it back into the garage.
Now it just looks like a standard P6 again. Time to break out the spot weld drill......
Interestingly I've had some emails from Rob Mellaart in Holland, he's been working on a coupe project, but is considering making a convertible instead, here's a couple of photo's he sent me.
Edited By webmaster on 1199039379